Brush Cleaner

How to use

1. Wash hands with soap and water. Dry thoroughly.
2. Use the fine side of a buffer to gently remove shine from natural nails.
3. Apply liquid #1, Prime Bond. Bursh lightly with low pressure to ensure an even application.
4. After applying the Prime Bond the first finger, dip finger in powder using a scooping motion. Tap finger against edge of jar remove excess powder off nail.
5. Repeat steps 3-4 on each finger on first hand. 
6. Apply a generous amount of #2, Instant Activator on all 5 fingers. Be sure to cover edges and cap off the tips of the nails. Allow to dry 2 minutes.
7. Repeat steps 3-6 on second hand.
8. Once dry, shape the nails with a file.
9. Use buffer to smooth out the surface of nails. Rinse hands with water, no soap. Dry hands and nails thoroughly.
10. Apply #3, Finishing Gloss to one hand. This first coat should be applied in 2-3 very quick brush strokes. Don't worry about getting too close to the cuticle area or the capping edges.
11. Wait 15 seconds, then continue on the same hand and apply a slower, more detailed second coat of #3 Finishing Gloss. Do not over brush as it may have an effect on the overall shine.
12. Repeat steps 11-12 on second hand.
13. After each completed application clean your brush with a clean lint free wipe.
14. DIP any hardened brush into the Brush Softener and watch as product build-up melts away. Dry the brush with a paper towel before using it again.